Introduction
For now you should have a better understanding on how all the element connect together. On this articles, you will learn on how to configure the cluster disk and also some cleanup on the network configuration.
Configuration
If you do follow the lab configuration as per my previous blog. You should be seeing the same screen as mine. But if you did not see this, suggest you to recheck again or sent me an email for correction
To start with , you need to open the cluster manager and you will see 3 cluster disk as shown below. The first cluster disk have been added as witness disk. Now you will need to add the balance of the disk.
To do that, first you right click the cluster disk and select the "add cluster shared volumes".
This is what would be the result after you have the disk the cluster shared volume as per highlighted.
The next thing we want to do is we need to label the network. To do that just double click on the network and set accordingly as per below.
Configuration for vlan2, make sure the allow clients to connect through this network is not check.
For vlan1, make sure you have the configuration as per below.
Other info
- Building a lab in Windows Server 2012 Part 1
- Configure the hyper-v host as preparing for the lab - Part 2
- Configure Active Directory on the VM - Part 3
- Configure the iSCSI storage - Part 4
- Install cluster on the file server as preparation for lab - Part 5
- How to validate cluster configuration - Part 6
- Configure cluster on the lab - Part 7
- Performing cleanup on the clustering networking - Part 8
- Preparing scale out file server - Part 9
- Configure file share and perform a test - Part 10
Summary
No comments:
Post a Comment